Axium AX4752 Guia de Instalação descarregar pdf (Página 12)

ADVANCED IR CONTROL

Fig 3

IR routing - discussed in ‘Typical System Configuration’ - is used to address specific centrally located

source components.

When several same brand and model source components are required in an installation, steps must be

taken to isolate the radiated IR from interfering with their discrete operation. This may be achieved

either by installing them in different cupboards or by using black IR blocking foam tape over the IR

emitters. The IR blocking foam tape is the preferred solution, since cupboard doors are often left

open.

Fig 3 shows a typical installation where several SAT receivers and tuners are required.

The dashed lines enclosing the source components represent IR isolation.

The second identical sources may be plugged into unpopulated AX4752 inputs, i.e. Tape, and Aux.

Axium controllers and sources may be re-labeled to identify their selection location.

Axium also offers an Emitter Expander ‘EX4’. This device simply provides connection for up to four

single or Dual IR emitters, and may be wired in parallel with the controller interface.

0V PG 1 2 3 4 # C D

Expansion Bus OutputRS232 Serial interface

Expansion Bus Input

TA TU UT

AX4752i

Multi-Room amplifier

Made in New Zealand

Audio Engineering Ltd

Data 12V IR1 0V

Data 12V IR2 0V

IR outputs

IR2

IR1+IR2

IR1

AMP ON

+12V

Tuner 2

SAT 2

Tuner 1

SAT 1

CD changer

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Sem comentários

Axium AX4752 Guia de Instalação Página 12